Handlekurven er tom
Handlekurven er tom
Du vil motta en e-post så snart produktet er på lager!
En ukjent feil har oppstått. Prøve igjen
All ObsidianWire Pro-Wired Electronics are super easy to install, and allow for solder-less pickup changes with ObsidianWire Plug, Play & Enjoy connectors.
The Three Pickup Telecaster®
Nashville wiring is a super popular Tele® mod that adds a third pickup between the traditional Telecaster® neck and bridge pickups. This gives you the standard 5-way control layout that you would usually find on a Stratocaster®.
The trouble is that in gaining a middle pickup, and the cool Strat quack from the neck & middle pickup combo, you lose the traditional Telecaster neck and bridge pickup combo.
The ObsidianWire Custom Nashville 7-Way for Tele® adds a push pull switch to the tone control, which connects the neck pickup directly to the guitars volume control. This allows the possibility to play the neck and bridge pickups together again, or even all three pickups at once.
'7 WAY' SWITCH ON (UP) |
'7 WAY' SWITCH OFF (DOWN) |
| Bridge + Neck | Bridge |
| Bridge & Middle + Neck | Bridge & Middle |
| Middle+ Neck | Middle |
| Neck & Middle | Neck & Middle |
| Neck | Neck |
To make your tone crystal clear at lower volumes we also include an ObsidianWire Custom Spec Treble Bleed Mod. This prevents tone 'muddiness' at low volumes by allowing high frequencies to pass along a separate path to your amp, rather than being stopped short by the increasing resistance at the volume control.
Potentiometers: Obsidian Custom CTS Pots 250K (+/-10%) Solid Shaft 1/4"
Capacitors: (150 Series Polyester Film 0.022uf) (+/-5%)
Switch: Genuine Oak 5 Way Switch
Jack: Pro-Wired Switchcraft J11 Mono
American series Fender® Nashville Telecasters - Direct Fit
Mexican series Fender® Nashville Telecasters - Direct Fit
Japanese Fender & Squiers 'Nashville' - You will need to purchase a genuine Fender USA control plate and new 1/4" knobs or ObsidianWire Control plate & Knobs
Fits genuine Fender Tele
Will not fit Squier or 'Metric' sized plates and knobs.
Always Check Hole Layout
Does NOT Fit:
- Thinline Telecaster
- G & L ASAT - May be fitted with adjustments to control slot size & new genuine Fender USA control plate and new 1/4" knobs or ObsidianWire Control plate & Knobs
- Other Guitars - We cannot guarantee that these will fit any other guitar.
Note: Aftermarket control plates will NOT fit. We recommend a genuine Fender control plate – Part Number: 099-2058-000 or equivalend
Use US spec 1/4" Solid shaft controls. We recommend that you check your knobs are the correct size and replace them if necessary.
Varenr KTCP70C
Kluson USA kontrollplate for montering av mikrofonvender, volum- og tonekontroll. God USA kvalitet. Hulldimensjon og avstand lik standard Fender kontrollplate. Hullet for venderen er litt lenger...
Varenr KTCP70N
Kluson USA kontrollplate for montering av mikrofonvender, volum- og tonekontroll. God USA kvalitet. Hulldimensjon og avstand lik standard Fender kontrollplate. Hullet for venderen er litt lenger...
Varenr KTCP70G
Kluson USA kontrollplate for montering av mikrofonvender, volum- og tonekontroll. God USA kvalitet. Hulldimensjon og avstand lik standard Fender kontrollplate. Hullet for venderen er litt lenger...
Varenr KTCP70B
Kluson USA kontrollplate for montering av mikrofonvender, volum- og tonekontroll. God USA kvalitet. Hulldimensjon og avstand lik standard Fender kontrollplate. Hullet for venderen er litt lenger...
